China Safety Science Journal ›› 2020, Vol. 30 ›› Issue (8): 37-43.doi: 10.16265/j.cnki.issn1003-3033.2020.08.006

• Safety engineering technology • Previous Articles     Next Articles

Study on overburden failure height of fully mechanized mining face in Mengxi deep mining area

ZHANG Yupeng1, ZHANG Yujun2,3, LIU Yitao4, SONG Yejie2,3, ZHAO Qiuyang2,3   

  1. 1 China Coal Northwest Energy Limited, Ordos Inner Mongolia 017000, China;
    2 CCTEG Coal Mining Research Institute Beijing 100013, China;
    3 Department of Coal Mining & Designing, Tiandi Science & Technology Co., Ltd., Beijing 100013, China;
    4 Wushenqi Mengda Mining Co., Ltd., Ordos Inner Mongolia 017000 China
  • Received:2020-05-15 Revised:2020-07-12 Online:2020-08-28 Published:2021-07-15

Abstract: In order to address difficulty in predicting height of overburden failure accurately under threat of multi-layer aquifer in Mengxi deep mining area, failure height of fully mechanized mining face was studied through on-site measurement, numerical simulation and physical simulation method. Firstly, development height of water-conducting fracture zone under condition of full mining of thick coal seam in Nalinhe No.2 mine was measured based on combined observation of well-ground boreholes, water injection and camera technology. Then, numerical and physical similarity models were constructed, and calculation method of overburden failure height in Mengxi mining area was determined according to regression analysis of measured data of mines with similar conditions in China. The results show that ratio of water-conducting fracture zone height to mining height is 17.1-22.06 from on-sit measurement and 15-18.8 by similar simulation, numerical simulation and theoretical calculation. It is estimated that overburden failure height of fully mechanized mining face can be 18 times of mining height in Mengxi deep mine area.

Key words: deep mining area, high fully mechanized mining, overburden failure, drilling water injection, camera

CLC Number: